Installation Instructions |
1
Mark the area where you want to install your Sta-Right™ Landscape Edging. Use a string line for straight sections or a garden hose to make gentle curves.
|
2
Using a shovel or spade, cleanly cut the edge of your beds. Remove any excess grass and soil. Dig down about 38 mm (1½”) and create a level shelf so Sta-Right™ is slightly above grade after installation.
|
3
Cut the back support on sections where you will have curves. Use heavy duty shears or a hacksaw to cut Sta-Right™. Helpful hint: If you hold the edging with the side wall facing down and cut the back support on an angle, Sta-Right™ will bend easily to make inside and outside curves.
|
4
Once Sta-Right™ has been cut, flex the piece to make inside or outside curves. |
5
Connect sections of Sta-Right™ using the patented vertical connection system. Slide the tongue on one section down the groove on another to engage the two pieces. Use a steel spike at the intersection when installing to secure the connection.
|
6
If landscape fabric is being used, place it in your bed before securing Sta-Right™. Place Sta-Right™ along the cut edge of your bed and secure it with the steel spikes included in the package. Place each spike about 40 cm (16”) apart.
|
7
Use mulch or decorative landscape stone to cover your garden beds and the Sta-Right™ Landscape Edging.
|
|
| |
Download & Print |
